CCS | Doucet | Casket Machines
The CCS allows casket manufacturers to cut the cover at desired length. Casket top moves into the saw until the bridge or top desk component hits the reference stop. This reference stop moves up/down to allow casket top to pass over after the cutting cycle. When in place, a side pusher aligns the casket top along the lateral references to insure a straight cut across the width. When ready, the cutting cycle starts by pressing down the piece with top hold-down as the saw blade is making a linear motion across the width.
•Roller Conveyor, 36” wide by 7.5′ long
•Fixed lateral fencing along the roller conveyor
•Pneumatic reference stopper
•Saw carriage is powered by electric motor with timing belt